What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 18.06.2025 03:45
These are simplified answers to the original question, and does not change anything I wrote above.
First Sentence:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Why do a bra and panties have to match?
but this device (an Inductor) … impedes the rapid changes in the current.
He then asserts :
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
What are scads fish? What types are there?
He then describes Rainy Season and Lightning.
For this case there are devices called Metal oxide varistors (MOV).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This device then solves the entire problem.
This is where the MOV conducts again, and dissipated the energy.
At one ohm, the resistor has a maximum of 1 watt power.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
a photo is worth a thousand words.
What does a fuse do?
Northern Lights Alert: 8 States May See Aurora Borealis Monday Night - Forbes
This is where this question deviates from being a 'generic' question, and becomes more specific.
Here is a simplified AC power diagram.
The other is “what does a “fuse” do?”
There are two important concepts here.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
What do people with very high IQs do all day?
At least they know the answer if they wanted it.
the problem then depends on "how fast does the fuse operate?".
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
WhatsApp is adding ads to the Status screen - TechCrunch
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
ChatGPT's AI coder Codex now lets you choose the best solution - BleepingComputer
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The third is lightning and “how it gets conducted into a home.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then describes the function of a fuse.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What is your age now, and what age do you prefer to stay at forever?
A circuit breaker is similar, but is resettable.
[image of Common-mode choke]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
(Dc diagram shown, AC is similar).
Because the load is inductive, the current lags the voltage.(by a bit).
What are some disadvantages of living in rural areas? What are the advantages?
It also is a device that limits the change in current flow.
Now when you have a certain ac resistance, then a current flows in a loop.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Why are white women so hard to date?
One is “what exactly is in a ‘surge protector’ ? ”
what exactly is a ‘surge’ protector?
eight
A fuse is a non-resetable over current circuit protector.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
[old diagram got deleted by accident]
The bolt then partially travels down the line to your home.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
In schematic diagrams this is the symbol for a fuse:
Edit 2024–10.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
I post the exact comment here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What is lightning?
but I think this circuit , shows a few more pieces.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Upvotes:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This one hit behind the barn.
nine
so, what happens?
There are three different concepts here that are getting confused.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–10[John johnson John Johnson ]
It seems Mohan does not understand the difference between a comment and an Answer.
But… the neutral is now “floating” because of the 1 ohm resistance.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
But it can get overloaded, and no longer works.
An AC voltage/ current source, and an ac inductive load.
This is 'the assistant's answer'
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
These devices are installed between the “hot” and “neutral” and protective ground.